Williamson Automotive in Enderby, BC

Williamson Automotive in Enderby BC



Government Approved Inspection Facility

Government Approved Inspection Facility
~ Out of Province
~ New/Private/Rebuilt from salvage/notice and order.
~ Commercial truck with and without air brakes
~ Trailer inspection
~ New Vin palte/BC assigned VIN plate
~ LPG/propane/pressure fuel


Manufacturer's Scheduled Maintenance

Manufacturer's Scheduled Maintenance Facility
While we cannot honor the New Car Warranty that's included with the purchase of your car by the manufacturer, we can handle all maintenance and non-warranty related repairs for you. A dealership must handle the service covered by a new car warranty. We will let you know when your car dealer should do certain work that's covered by your factory warranty.


Engine Diagnostics

Engine Diagnostics
A set of tests using a scan tool and lab scope will help locate the source of poor engine performance or running problems. The vehicle's sensors, fuel pressure and emission systems are all checked by a highly trained Technician.


Engine Tune - Ups

Engine Tune - Ups
A necessary part of vehicle maintenance wherein the spark plugs, air filter, and fuel filter are replaced.


Electrical Work

Electrical Work
Tracing and locating shorts in the vehicle's electrical system, which includes window motors, door locks, taillights, headlights, and instrument clusters. Due to the complexity of a vehicle's electrical system, this work is best left to one of our highly trained technicians.


Fuel Injection

Fuel Injection
We monitor, maintain, or replace the components of a fuel injection system to keep the vehicle running at optimum performance.


Timing Belts

Timing Belts
We recommend replacing timing belts as a part of a standard maintenance program. Failure to do so can cause catastrophic engine damage.


Batteries/Charging Systems

Batteries/Charging Systems
The battery is tested for load capacity and the alternator is tested for amp/voltage output to sustain the charge of the battery. Parts are replaced as necessary.


Air Conditioning

Air Conditioning
The air conditioning system is checked for leaks, refridgerant level, and blower volume. Parts are replaced as necessary. When a leak is not detectable upon initial inspection, a dye is used to pinpoint the location.


Clutches/Flywheels

Clutches/Flywheels
Requires removal of a vehicle's transmission to replace a three part clutch assembly that includes pressure plate, disc, and throw-out bearing. The flywheel must also be machined. for optimum performance.


Shocks/Struts/CV Joints

Shocks/Struts/CV Joints
The shocks and struts control the ride of a vehicle and keep the wheels in contact with the road. Neither shocks nor struts can be repaired and the entire unit must be replaced. The boot covering the CV joint must be inspected for tears or breaks by a trained technician. This will prevent future damage from loss of lubrication.


Brakes

Brakes
All brake repairs begin with a thorough inspection to determine which parts or components need replacement or maintenance. Brake fluid is checked at the time of each oil change.


Cooling Systems/Radiators

Cooling Systems/Radiators
Our technicians check the engine cooling system for proper water and antifreeze/coolant level, leaks and proper flow. In order for the cooling system to operate properly, belts must be in good condition and there should be no restrictions.


Lube, Oil and Filter Change

Lube, Oil and Filter Change
We recommend changing engine oil and filter every 5,000 kilometers/3000 miles. While performing an oil change, our technicians check all fluids and top off as necessary. Most new vehicles do not require lubrication, as moving parts are lubricated and sealed at the factory. A complimentary inspection is included in evry service.